4/17/2023 0 Comments Pentair protocol adapter manualConnect the Four-Wire Cable: Run a four conductor cable (22 AWG UL approved) from the LoadĬenter or Power Center location to the adapter. This avoids having to run a separate four wire from the Load Center to the Protocol adapter.ġ. Note: Existing Indoor Control Panel - If there is an existing IntelliTouch Indoor Control Panel, you can tap directly into the wire in the home or pig tail off the connector in the Indoor Control Panel. For wireless router location requirement, refer to “ScreenLogic Location Requirements,” page 17. If the wireless router is too far from the pool area, then you may need to move the wireless router closer to the pool area by running an Ethernet cable from the DSL/Cable Modem connection out to the Protocol adapter and wireless router. Protocol Adapter Location: The IntelliTouch wireless router and Protocol adapter should be located inside in a dry environment, preferably near the home owners DSL/Cable modem. Before connecting the cable to the adapter, first determine the length of cable required for the connection. The IntelliTouch ScreenLogic Protocol adapter is connected to the Personality board located in the Load Center or Power Center via a four-wire cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |